Angled Physical Contact Polish (APC Polish)​​

Oct 21, 2025

Leave a message

Angled Physical Contact Polish (APC Polish)​​

Introduction

Application Requirements

System Specifications

Processing Flow

Customer Case

​Introduction​

 

​Application Requirements​

​Ultra-Low Roughness (Ra):​​ End-face roughness must be less than 20 nm, ideally achieving <5 nm to minimize optical scattering loss.

​Excellent Flatness:​​ The end face should be free of convexity or concavity to ensure perfect contact with the mating connector's Physical Contact (PC) or Angled Physical Contact (APC) surface.

​Defect-Free:​​ The surface must be free of scratches, cracks, and residual particulate contamination.

​Angle Accuracy:​​ The tilt angle (θ) must be precisely controlled, typically requiring a tolerance within ±0.2°.

​Orientation Alignment:​​ The direction of the tilt angle must be aligned with the connector's key to ensure correct angular matching during mating.

​Edge Integrity:​​ The process of creating the angled surface must prevent chipping at the fiber edge, which could become a new reflection point or stress concentrator.

​System Specifications​

The HSM Precision Grinding and Polishing System provides a full-process solution.

​Processing Flow​

​Sample Preparation​

Secure the fiber end face using a specially customized angle fixture. The angle fixture, along with the fiber's pigtail, is then fixed onto a custom holder to prevent the pigtail from interfering with the process flow.

​Polishing Preparation​

Replace the process platen with a polishing pad. Pre-condition the pad for 30 minutes and switch the abrasive to HSM specialized polishing slurry.

Control key parameters via the graphical interface:

Polishing platen speed: ≤ 15 rpm

Slurry flow rate: Monitored by a real-time drip feed control system (reduces waste)

Pressure load: 0-100 g

​Target:​​ Achieve ultra-low roughness; end-face roughness must be less than 20 nm, ideally <5 nm, to minimize optical scattering loss.

​Results​

The fiber end faces processed by the HSM-CMP system achieved the following performance:

​Customer Case​

A customer used the HSM-CMP system to perform a 7° angled polish on 20 optical fibers with the following process and results:

​Initial State:​​ RMS = 80 nm, with visible cutting marks on the surface.

​After 4 hours of polishing:​​ RMS = 15 nm, with localized areas reaching 8 nm.

​Surface Appearance:​​ Under microscope inspection, the end face was flat and free of scratches.

​Suitability:​​ No risk of fracture or cracks.

​Cleaning Effect:​​ Immersion in a cleaning solution removed most surface contaminants.

​Technical Validation​

Schematic: Diagram of the fiber end face after processing by the HSM-CMP system.

​ISO 4287 - Roughness (S-L)​

info-808-606

info-808-606

 

info-808-606info-788-606info-1024-1024

Send Inquiry